Connecting To The J-Web Interface; Connecting To The Cli Locally; Connecting To The Cli Remotely - Juniper J-series Services Router J2350 Hardware Manual

This section contains the following topics:

Connecting to the J-Web Interface

If you plan to use the J-Web interface to configure the Services Router, you must
connect through one of the built-in Ethernet management ports, as shown in
Figure 54 on page 98 and Figure 55 on page 98.
When the Services Router is powered on for the first time, the system looks for a
DHCP server, and if it does not find one, it assigns an IP address within the
192.168.1.0/24
To connect to the J-Web interface through port 0 on the router (see Figure 54 on page
98 and Figure 55 on page 98):
1.
2.
3.
4.
5.
6.
7.
8.
9.
NOTE: You must manually configure the IP address for the management port you
are using before you save your initial configuration. When you save the configuration
for the first time, you will lose the connection to the router if you have not manually
configured the IP address. If you lose connection through the management interface,
you must connect through the console port.
Connecting to the J-Web Interface on page 97
Connecting to the CLI Locally on page 98
Connecting to the CLI Remotely on page 100
subnetwork to any devices connected to it.
On the management device, such as a PC or laptop, you use to access the J-Web
interface, verify that the address of the port that you connect to the router is set
to one of the following:
An Ethernet address on the
192.168.1.1
An Ethernet address from a DHCP server
Turn off the power to the management device.
Plug one end of the Ethernet cable into the Ethernet port on the management
device.
Connect the other end of the Ethernet cable to the built-in Ethernet port on the
router.
Power on the router by pressing the power button on the front panel.
Wait until the LED on the front panel turns solid green.
STATUS
Turn on the power to the management device. The router assigns an IP address
to the management device within the
is configured to use DHCP.
From the management device, open a Web browser and enter the IP address
in the address field. The Set Up Quick Configuration page appears.
192.168.1.1
Configure basic settings for your router as described in "Configuring Basic Settings
with J-Web Quick Configuration" on page 103.
Chapter 6: Establishing Basic Connectivity
192.168.1/24 subnetwork other than
192.168.1.0/24 subnetwork if the device
Connecting to a Services Router
97