Juniper J-series Services Router J2350 Hardware Manual page 159

J-series services routers software with enhanced services
Hide thumbs Also See for J-series Services Router J2350:
Table of Contents

Advertisement

1.
2.
3.
4.
5.
6.
Installing the USB Storage Device
To install the USB storage device:
NOTE: For a list of supported USB storage devices, see the JUNOS Software with
Enhanced Services Release Notes at
1.
2.
Verify the device that the router used to boot, by running the
command from the CLI. For example:
user@host> show system storage
Filesystem
512-blocks
/dev/ad0s1a
...
The boot device is mounted on
The external compact flash is located at
at
da0
. This example shows that the router booted from the internal compact
flash.
If the
show system storage
external compact flash, you need to power off the router before replacing the
compact flash.
Place an electrostatic bag or antistatic mat on a flat, stable surface.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and
connect the strap to the ESD point on the chassis, or to an outside ESD point if
the router is disconnected from earth ground. For more information about ESD,
see "Preventing Electrostatic Discharge Damage" on page 201.
Press and release the power button to power off the router. Wait for the
LED to turn off before you remove the compact flash.
Skip this step, if the router did not boot from the external compact flash (see
Step 1).
Gently grasp the USB storage device and slide it out of the USB port.
Place the USB storage device on the antistatic mat or in the electrostatic bag.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and
connect the strap to the ESD point on the chassis, or to an outside ESD point if
the router is disconnected from earth ground. For more information about ESD,
see "Preventing Electrostatic Discharge Damage" on page 201.
Orient the USB storage device with the USB port on the front panel of the router.
Chapter 8: Replacing Hardware Components
Used
Avail Capacity Mounted on
218254
175546
40526
/
. The internal compact flash is located at
. The USB storage device is located
ad2
output indicates that the router booted from the
.
http://www.juniper.net
Replacing USB Storage Devices
show system storage
81%
/
ad0
.
POWER
135

Advertisement

Table of Contents
loading

This manual is also suitable for:

J-seriesJ2320J4350J6350

Table of Contents