Locate the Crypto Module on the system board (see Figure 84 on page 150).
6.
Using a Phillips screwdriver remove the screw, as shown in Figure 85 on page 151.
7.
Figure 85: Removing a J4350 or J6350 Crypto Module Screw
Pull the white release clips on either side of the Crypto Module out to either side,
8.
as shown in Figure 86 on page 151, to tilt the Crypto Module upward.
Figure 86: Removing and Installing a J4350 or J6350 Crypto Accelerator Module
Slide the Crypto Module out of its socket.
9.
Remove the standoff washer that was under the Crypto Module.
10.
Place the Crypto Module on the antistatic mat or in the electrostatic bag.
11.
Replacing Crypto Accelerator Modules on J4350 and J6350 Routers
Chapter 8: Replacing Hardware Components
151