Configuring Basic Settings With J-Web Quick Configuration - Juniper J-series Services Router J2350 Hardware Manual
J-series services routers software with enhanced services
Hide thumbs
Also See for J-series Services Router J2350:
- User manual (675 pages) ,
- Getting started manual (332 pages) ,
- Quick start quide (26 pages)
Table of Contents
Advertisement
6.
7.
Configuring Basic Settings with J-Web Quick Configuration
J-Web Quick Configuration allows you to configure basic settings. Figure 58 on page
103 shows the Quick Configuration page for basic setup.
Figure 58: Set Up Quick Configuration Page
Before you configure the router, gather the information described in "Before You
Begin" on page 95.
An
response verifies that the modem communicates successfully with the
OK
COM port on the PC or laptop.
To dial the modem that is connected to the console port on the router, enter
ATDT remote-modem-number
to the console port on the router is
The router login prompt appears.
Log in as the user
root
. No password is required at initial connection, but you
must assign a root password before committing any configuration settings.
Configuring Basic Settings with J-Web Quick Configuration
Chapter 6: Establishing Basic Connectivity
. For example, if the number of the modem connected
, enter
0013033033030
.
ATDT 0013033033030
103
Advertisement
Table of Contents
