Configuring Basic Settings With J-Web Quick Configuration - Juniper J4350 Getting Started Manual

3.
4.
5.
6.
7.

Configuring Basic Settings with J-Web Quick Configuration

J-Web Quick Configuration allows you to configure basic settings. Figure 25
shows the Quick Configuration page for basic setup.
Before you configure the router, gather the information described
in "Before You Begin" on page 98.
To configure basic settings with J-Web Quick Configuration:
1.
2.
3.
4.
Select the port to which the modem is connected (for example,
COM
Configure the port settings as follows:
Bits per second: 9600
Data bits: 8
Parity: None
Stop bits: 1
Flow control: None
In the HyperTerminal window, enter
An response verifies that the modem communicates successfully with
OK
the COM port on the PC or laptop.
To dial the modem that is connected to the console port on the router, enter
. For example, if the number of the modem connected
ATDT remote-modem-number
to the console port on the router is
The router login prompt appears.
Log in as the user "root". No password is required at initial connection, but you
must assign a root password before committing any configuration settings.
If you have not already done so, connect a management device to the
interface on port 0/0. For instructions, see "Connecting to the J-Web Interface"
on page 99.
If the Set Up Quick Configuration page is not displayed, select
Configuration>Quick Configuration >Set Up.
Enter information into the Set Up Quick Configuration page, as described in
Table 35.
Click one of the following buttons:
To apply the configuration and stay in the Set Up Quick Configuration
page, click Apply.
Configuring Basic Settings with J-Web Quick Configuration
Establishing Basic Connectivity
.
AT
, enter
0013033033030 ATDT 0013033033030
).
COM1
.
ge-0/0/0
105