Extron electronics DMP 64 User Manual page 94

Tools
The Tools menu contains the following items and sub-menu:
•
Presets — Provides three options:
о Mark All Items — Mark (select) all parts of the current
configuration (excluding presets), including processors
and mix-points to save as a partial preset.
о Save Preset — Save the currently marked processors,
and mix-points as a partial preset.
о Clear Marked Items — Unmark (deselect) all parts of
the current configuration (excluding presets), including
processors and mix-points.
• Protected Configuration — Live mode only. Allows a user (typically the installer)
to save and recall a protected configuration. The protected configuration is useful to
establish the all parameters and values (with the exception of the device IP address)
in a known state, either as a troubleshooting tool or as a baseline configuration. The
protected configuration, once saved in the device, is always present and cannot be
overwritten without entering a user-defined Personal Identification Number (PIN)
password. The protected configuration is restored without a PIN:
NOTE: The default PIN is 0000.
о Save — Save the current configuration (excluding presets), including processors
and mixes as a password protected configuration. The DSP Configurator program
prompts for a PIN to save.
о Recall — Recall the protected configuration.
о Change PIN — Change the PIN associated with the protected configuration.
• Configure Digital I/O Ports — Live mode only. Opens a utility to configure digital
I/O ports. The DMP 64 provides six digital I/O ports that may be used to trigger
external events from DMP 64 actions, or for external events to trigger DMP actions.
Digital I/O Ports
See for details.
• Connect to / Disconnect from Device (depending on Emulate or Live mode) —
Performs the same functions as the Mode
• Issue RESET Command — Initializes and clears the following: mix-points, presets,
processor blocks, and gain blocks. This reset is identical to the E ZXXX } SIS
SIS Programming and
command (see
• Save changes to device — Live mode only. Saves configuration changes made in
the DSP Configurator program to the DMP 64.
• Firmware Loader — Calls the Firmware Loader program, which allows updating the
firmware without taking the DMP 64 out of service. See
• Configure Groups — Opens the configure groups dialog box. See
• Device Settings — Live mode only. Opens a dialog box that provides a means to
change the IP address, set administrator and user passwords, and to select the serial
port baud rate.
and Mode
Emulate Live
Control).
Firmware
DMP 64 • Software Control
buttons.
Loader.
Group Masters.
88