Extron electronics DMP 64 User Manual page 111

Tools
The Tools menu contains three selections:
• Clear All Groups - clears all group members and group master parameters.
• Increment/Decrement Simulator - allows the user to test increment/decrement values
(see below for more information)
• Group Details Report - generates a report, listing all group masters and membership.
Clear All Groups
Click
Tools | Clear All Groups
limits will also be cleared.
Increment/Decrement Simulator
The Increment/Decrement Simulator provides a control for increment and decrement, with the
ability to set increment and decrement values. This control is temporary, since this value is not
remembered in the device.
To use the Increment/Decrement Simulator:
1.
Select Tools | Increment/Decrement Simulator
2.
Select the group to be controlled from the
dialog box appears:
Figure 54.
Increment/Decrement Simulator Dialog Box
NOTE: The
Number of Group Members:
to be affected.
3.
Enter an increment value and a decrement value. The default value is 1.
NOTE: The size of the increment can be changed by typing a value in the Increment
Value or Decrement Value field. Values can be as large as the maximum
range of the control or as fine as 0.1 dB. For groups controlling mute, 1 is the
only valid value.
4.
Click the increment and decrement buttons as needed. The group master control increases
or decreases by the set value to the top or bottom of its soft limit range.
NOTE: If set, soft limits cannot be exceeded.
to delete all groups and reset all group memberships. All soft
from the Tools menu.
Select Group
readout indicates the number of controls
drop-down list. The following
DMP 64 • Software Control 105