Sis Programming And Control; Connection Options - Extron electronics DMP 64 User Manual

SIS Programming
and Control
This section describes SIS programming and control of the DMP 64, including:
•
•
•
•
•

Connection Options

The DMP 64 Digital Matrix Processor can be remotely connected via a host computer or
other device (such as a control system) attached to the rear panel RS-232 port or LAN port,
or the front panel USB Config port.
The DMP 64 can be set up and controlled using the Extron
SIS (Simple Instruction Set) commands, embedded Web pages, or DSP Configurator
software. See chapter 2 for pin assignments and details on the configuration and control
port connections. For information on DSP Configurator see
embedded Web pages, see
SIS commands may be executed using the Extron Electronics DataViewer program, which
may be found on the Software Products DVD included with the product.
DMP 64 RS-232 protocol:
•
•
•
NOTE: Both rear panel configuration ports require 38400 baud communication.
See
Connection Options
Host-to-device communications
Command/Response Table for Basic SIS Commands
Command/Response Tables for DSP SIS Commands
Special Characters
HTML
38400 baud • no parity
8 data bits • no flow contro
1 stop bit
This is a higher speed than many other Extron Electronics products use. The
DMP 64 control software automatically sets the connection for the appropriate
speed. If using HyperTerminal or a similar application, make sure the PC or
control system connected to these ports is set for 38400 baud.
RS-232 Ports, for additional details on connecting the RS-232 port.
DMP Software
Operation.
DMP 64 • SIS Programming and Control
and for the
49