Extron electronics DMP 64 User Manual page 118

8.
To push all of the DSP Configurator gain and processor block adjustments
(configuration), and all presets to the DMP 64, proceed to step 9.
To tailor the push (push only the configuration, only the presets, or the configuration
and selected presets), click the
a. Select the
Custom
b.
Select the desired checkbox(es);
Push Configuration
NOTE:
Push Configuration
settings. It does not include partial presets.
c. If was clicked in step 8b, click
Push Presets
choose specific presets.
•
If Selected was clicked, click
•
If was clicked (equivalent to a standard push), click
All
step 9.
d. If was clicked in step 8c, the Synchronize with Device dialog box (7b)
Selected
reappears. Click
OK
e.
Select the desired partial presets to push by clicking the appropriate checkbox(es).
f. Click . — Proceed to step 10.
OK
9.
Click . The DSP Configurator program is connected live to the device and the
OK
processors, and presets are pushed or pulled as selected, completing the selection of
Live mode.
10.
If changes were made to the DSP parameters (including mix-point, gain and/or
processor blocks) since the last file save, the DSP Configurator prompts to save the
file. Click or , as desired,
Yes No
If a password was required and not entered or if an incorrect password was entered,
the program prompts for the password.
The configuration and/or presets will be uploaded to the DMP 64.
button and proceed to step 8a.
Advanced
radio button.
Push Configuration
is the only box checked, click
includes all mix-point, gain and processor block
All
and proceed to step 8d.
OK
. The presets dialog box appears.
and/or . If
Push Presets
and proceed to step 9.
OK
to select all presets or
Selected
and proceed to
OK
DMP 64 • Software Control
to
112