Through-Desk Mounting - Extron electronics DMP 64 User Manual

Through-desk Mounting

Mount the DMP 64 through a desk or podium as follows:
1. Cut the proper sized hole in the mounting surface.
2.
Hold the DMP 64 with the attached brackets against the underside of the table or
other furniture. Mark the location of the screw holes of the bracket on the mounting
surface.
3.
Drill 3/32 inch (2 mm) diameter pilot holes, 1/4 inch (6.3 mm) deep in the mounting
surface at the marked screw locations.
4.
Insert four #8 wood screws through the bracket and into the four pilot holes. Tighten
all four screws to secure the unit in place.
Figure 3. MBD 129, Through-desk Mounting
DMP 64 • Installation 8