Dmp 64 Hardware Reset Modes - Extron electronics DMP 64 User Manual

DMP 64 Hardware Reset Modes

Mode Mode Activation
Hold the reset button while
1
applying power.
NOTE: After a mode 1 reset, update the DMP 64
firmware to the latest version. DO NOT
operate the firmware version that results
from this mode reset.
With power on, press and hold the
3
Reset button until the Power LED
blinks once (3 sec.), then release
and within 1 second press Reset
momentarily (<1 sec).
NOTE: Nothings happens if the momenary press
does not occur within 1 second.
4 Press and hold the Reset button for
about 6 sec. until the Power LED
blinks twice (once at 3 sec., again
at 6 sec.), then release and within
1 second press Reset momentarily
(< 1 sec.).
NOTE: Nothing happens if the momentary press
does not occur within 1 second.
5 Press and hold the Reset button for
about 9 sec. until the Power LED
blinks three times (once at 3 sec.,
again at 6 sec., again at 9 sec.),
then release and within 1 second
press Reset momentarily (< 1 sec.).
NOTE: Nothing happens if the momentary press
does not occur within 1 second.
DMP 64 Reset Mode Summary
Result
The DMP 64 reverts to the factory
default firmware.
Event scripting does not start if
the DMP 64 is powered on in this
mode. All user files and settings
(drivers, adjustments, IP settins,
etc.) are maintained.
NOTE: If you do not want to update the firmware,
or perform a mode 1 reset by mistake,
cycle power to the DMP 64 to return to the
firmware version running prior to the reset.
Mode 3 toggles events on or off.
Front panel level indicators blink
twice to indicate events has toggled
on, or three times to indicate event
logging has toggled off.
Mode 4:
• Enables ARP capability.
• Set the IP address to default.
• Sets the subnet to default.
• Sets the gateway address to
default.
• Sets port mapping back to
default.
• Turns DHCP off.
• Turns events off.
Mode 5 performs a complete
reset to factory defaults, except
for firmware:
• Does everything mode 4 reset
does.
• All mix-points set muted and
set to 0 dB..
• All outputs unmuted and set to
0 dB.
• DSP Processing returned to
defaults and bypassed.
• All inputs muted and set to
0 dB.
• All presets and group master
memory cleared.
Purpose/Notes
This mode reverts to the
factory default firmware
version if incompatibilty
issus arise with user-loaded
firmware.
NOTE: User-defined Web pages may
not work correctly if using an
earlier firmware version.
Useful for troubleshooting
Enables resetting IP address
information using ARP and
MAC address.
Useful to start over with
configuration or uploading,
and to replace events.
DMP 64 • Reference Information 144