Extron electronics DMP 64 User Manual page 93

Edit
• Cut — Removes all parameters of a selected processor
block or set of selected blocks to the clipboard. If not
followed by a Paste command to a different block,
the parameters are restored.
NOTE: Processor blocks are not removed from the processor stream after a
and a subsequent
Processor blocks and their parameters can be pasted only into another
block of the same type. For example, the input 1 filter block and all of its
parameters can be copied to the input 2 filter block but not to the input 1
delay block.
• Copy — Copies all of the parameters of a selected processor block, gain block, or set
of selected blocks to the clipboard.
• Paste — Inserts processor blocks and their parameters from the clipboard into the
DSP Configurator program at the location selected.
View
• Meter Bridge — Opens a Meters dialog box with
real-time meters that monitor signal levels at each
input and output.
NOTE:
Meter Bridge
port.
Figure 44. Meter Bridge
•
Re-enable all dialogs — Re-enables all dialog boxes, the pop-up windows that allow
changes to block parameters.
• Error log — A troubleshooting tool, error log lists error messages.
• Group Controls — Opens the Group Controls dialog box. See
operation. Only the parameters are moved.
Paste
is available in Live mode only while connected via the LAN
Cut
Group Masters.
DMP 64 • Software Control 87