Extron electronics DMP 64 User Manual page 115

Selecting Live Mode and Pushing or Pulling Data
To switch from emulate mode to live mode:
1.
Select the desired connection to the DMP 64 and make the proper connections.
NOTE: Extron recommends connection via the Ethernet LAN port when using
2.
Click the Mode
Communication Type Selection
2
3
4a
or
4b
4c
Figure 56.
3. If necessary and as desired, click either the:
•
TCP/IP tab (for connection via the LAN port (preferred) — proceed to step 4,
• RS-232 tab (for connection via either of the rear panel RS-232 ports — proceed
to step 5,
•
USB tab (for connection via the front panel configuration port — proceed to
step 6.
4. If TCP/IP was selected in step 3:
a.
Observe the IP address field in the IP connection window. The field displays the
last IP address entered.
•
If the IP Address field is correct, proceed to step 4b.
• If the address is not correct, either click in the IP Address field and enter
the IP address or click on the scroll down button ( ) to open a drop-down list
and select from among the recently used addresses. Proceed to step 4b.
b. If the device is password protected, click in the password field and enter the
appropriate administrator password.
c.
Click
DSP Configurator.
button (see b in figure 56). The
Live
window appears.
3
5a
5b
5c
Selecting Live Mode
NOTE: If the local system administrators have not changed the value, the
factory-specified default, 192.168.254.254, is the correct value
for this field.
OK .
3
Extron USB device
or
6b
DMP 64 • Software Control
6a
109