Special Characters - Extron electronics DMP 64 User Manual

Symbol definitions
]
=
CR/LF (carriage return/line feed) (hex 0D 0A)
}
=
Carriage return (no line feed, hex 0D)
(use the pipe character,
=
Space character
•
|
=
Pipe (vertical bar) character
E
=
Escape key (hex 1B) (use W instead of Esc for Web browsers)
X6)
=
Gain and trim control or mix-point select
X6!
= Level value;
(
mix-point gain
(
post-mixer trim
X6@
a
= (
Mic/line gain
X6#
=
Level value:
(
pre-mixer gain
e
(
output volume
X6$
=
Mute status
X6%
=
Group master group number
X6^
= Group fader setting
X6&
= Group fader increment
X6*
=
Group fader soft limit
X6(
=
Group type
X7)
=
Personal Identification Number (PIN)
X7!
= Protected configuration status

Special Characters

The HTML language reserves certain characters for specific functions. The device will not
accept these characters as part of preset names, the device's name, passwords, or locally
created file names.
The DMP 64 rejects the following characters:
{space (spaces are oK for names)} + } ~ , @ = ' [ ] { } < > ' " semicolon (;) colon
(:) | \ and ?.
|
, for Web browser commands))
See the tables on page 74.
See the table on page 75 through 77.
c
) -35 dB to + 25 dB, (1698 to 2298 ) in 0.1 dB increments.
, and
d
) NOTE:
) See the table on page 78 through 81.
level value
-18.0 dB to +80 dB, (1868 to 2848 ) in 0.1 dB increments.
See the table on page 82 through 85.
b
)
100.0 dB to +12.0 dB, (1048 to 2168) in 0.1 dB increments.
, and
NOTE:
)
0 = unmute
1 = mute
01 – 32
dB value, in 0.1 dB increments using negative numbers but not decimal places.
The valid range depends on the type of gain block that is assigned to the group
number (
a
= -180 to 800 (-18.0 dB to +80.0 dB)
b
= -1000 to 120 (-100.0 dB to +12.0 dB)
c
= -350 to 250 (-35.0 dB to + 25.0 dB)
d
= -120 to 120 (-12.0 dB to +12.0 dB)
e
= -1000 to 000 (-100.0 dB to +0.0 dB)
NOTE:
dB value, in 0.1 dB increments, to raise or lower a group fader
dB value, in 0.1 dB increments. The valid range
for the gain block grouped in
6= gain
12 = mute
Four numeric digits, default = 0000
0 = no protected configuration saved
1 = protected configuration saved
Post-mixer, -12 dB to +12 dB (1928 to 2168) only.
Output volume, -100.0 dB to +0.0 dB (1048 to 2048 ) only.
X6%
) specified in the command:
Leading zeros are ignored.
X6%
.
DMP 64 • SIS Programming and Control
X6^
must be within the range
62