Rs-232 Ports; Usb Port (Front Panel) - Extron electronics DMP 64 User Manual

USB port details:
The Extron USB driver must be installed before use. See
installation instructions.
LAN port defaults:
DMP 64 IP address: 192.168.254.254
gateway IP address: 0.0.0.0
subnet mask: 255.255.0.0

RS-232 Ports

The DMP 64 has two serial ports that can be connected to a host device such as a
computer running the HyperTerminal utility, or the DataViewer utility. The ports make
serial control of the switcher possible. Use the protocol information listed above to make
the connection. Once the connection is made, see
later in this section for SIS programming details.

USB Port (front panel)

The DMP 64 has a front panel USB port that can be connected to a host device such as
a computer running the HyperTerminal utility, or the DataViewer utility. The port makes
serial control of the switcher possible. Once the connection is established, see
device communications
DHCP: off
later in this section for SIS programming details.
Install the USB Driver
Host-to-device communications
DMP 64 • SIS Programming and Control
for driver
Host-to-
50