Dmp Software; Software Control - Extron electronics DMP 64 User Manual

DMP Software

This section describes the control software for the DMP 64, including:
•
•
•
•
•
•
•
•

Software Control

The DMP 64 can be controlled using the DSP Configurator software, SIS commands
through hyper terminal or DataViewer, or using embedded WebPages. IP Link functions
will be available through network connection including global viewer functionality.
The DMP 64 has the following connection options:
•
•
•
Software Control
Embedded Web Pages
Windows-based Program Control
DSP Configurator Program
Digital I/O Ports
Emulate Mode vs. Live Mode
DSP Configurator Windows menus
Optimizing Audio Levels
RS-232 — One single stack 3-pole, 3.5 mm captive screw connector is used for bi-
directional RS-232 (±5 V) serial control.
See Rear Panel Features and
RS-232 port.
LAN — 10 Mbps, 100 Mbps, half duplex, full duplex connections are supported. Two
LEDs indicate connection and activity status. The device has the following default
Ethernet configurations:
IP Address: 192.168.254.254
Subnet Mask: 255.255.0.0
Rear Panel Features and
See
details on connecting the LAN.
USB 2.0 — A Mini B-type USB connector located on the front panel provides high-
speed USB 2.0 connectivity to a host computer, backward compatible to 1.0.
Cabling, for additional details on connecting the
Default Gateway: 0.0.0.0
DHCP: OFF
Cabling, and Connection Options
DMP 64 • Software Control
for additional
78