Replacing Expansion Cards; Preliminary Steps; Removing An Expansion Card; Installing An Expansion Card - Fujitsu PRIMERGY TX1310 M1 Upgrade And Maintenance Manual

Expansion cards and backup units
9.3.3

Replacing expansion cards

Upgrade and Repair Unit
(URU)
Tools: Phillips PH2 / (+) No. 2 screw driver (only for installing slot brackets)
Note on network settings recovery
I
When replacing network controllers or the system board, network
configuration settings in the operating system will be lost and replaced
by default values. This applies to all static IP address and LAN teaming
configurations.
Ensure to note down your current network settings before replacing a
network controller or the system board.
9.3.3.1

Preliminary steps

"Disabling BitLocker functionality" on page 63
Ê
"Shutting down the server" on page 40
Ê
"Disconnecting the server from the mains" on page 41
Ê
"Removing the side cover" on page 42
Ê
9.3.3.2

Removing an expansion card

Ê Remove the defective expansion card as described in section
expansion cards" on page
Ê If the slot bracket on the defective expansion card is to be reused, remove it
from the expansion card as described in section
on page 122.
9.3.3.3

Installing an expansion card

Ê If applicable, install a slot bracket on the new expansion card as described
in section "Installing a slot bracket" on page
Ê Install the new expansion card as described in section
cards" on page
130
127.
123.
Upgrade and Maintenance Manual
Hardware: 5 minutes
Software: 5 minutes
"Removing a slot bracket"
118.
"Installing expansion
"Removing
TX1310 M1