Looking Up Changed Mac / Wwn Addresses; Looking Up Mac Addresses; Using The Chassis Id Prom Tool - Fujitsu PRIMERGY TX1310 M1 Upgrade And Maintenance Manual

Basic software procedures
V
CAUTION!
The system is now operational, however, data redundancy will not be
available until the RAID array rebuild is complete. Depending on the hard
disk drive capacity the overall process can take up to several hours, in
some cases even days.
I
You may notice a slight performance impact during rebuild.

5.2.10 Looking up changed MAC / WWN addresses

When replacing a network controller or SFP+ transceiver module, the MAC
(Media Access Control) and WWN (World Wide Name) addresses will change.
I
In addition to the procedures described below, MAC / WWN addresses
can also be found on the type label attached to a network controller or
system board.

5.2.10.1 Looking up MAC addresses

Ê Enter the BIOS.
Ê Depending on the number of network controllers in your system, you will find
one or several Port Configuration menu items.
Use the arrow key ç to scroll to the right and browse all available tabs.
Each Port Configuration tab will display detailed information on the related
network controller, including its MAC address.
Ê Note down the new 12-digit MAC address.
Ê Press [Esc] to exit the BIOS.
Ê Inform the customer about the changed MAC address.

5.2.11 Using the Chassis ID Prom Tool

The Chassis ID EPROM located on the system board contains system
information like server name and model, housing type, serial number and
manufacturing data.
76 Upgrade and Maintenance Manual
TX1310 M1