Preliminary Steps - Fujitsu PRIMERGY TX1310 M1 Upgrade And Maintenance Manual

V
CAUTION!
– Before replacing the system board, ask the customer whether TPM
functionality is used.
– If the customer is using TPM functionality, remove the TPM from the
old system board and install it on the new system board.
Advise your contact persons that they must provide you with TPM
backup copies. For security reasons, the TPM must be restored / re-
saved by the customer. After installing a new system board the TPM
must be enabled. You may not clear the TPM data.
If the contact persons DO NOT have a backup copy available, inform
them that replacing the TPM will cause to lose all data.
Note on network settings recovery
I
When replacing network controllers or the system board, network
configuration settings in the operating system will be lost and replaced
by default values. This applies to all static IP address and LAN teaming
configurations.
Ensure to note down your current network settings before replacing a
network controller or the system board.

14.4.1 Preliminary steps

Ê If applicable, backup the BIOS settings manually.
"Disabling BitLocker functionality" on page 63
Ê
"Shutting down the server" on page 40
Ê
"Disconnecting the server from the mains" on page 41
Ê
Ê Disconnect all external cables.
"Removing the side cover" on page 42
Ê
Ê Remove all accessible drives as described in section
drives" on page
"Removing the front cover" on page 46
Ê
"Removing the HDD cage" on page 56
Ê
TX1310 M1
43.
Upgrade and Maintenance Manual
System board and components
"Removing accessible
207