Ce Conformity; Fcc Class A Compliance Statement - Fujitsu PRIMERGY TX1310 M1 Upgrade And Maintenance Manual

Important information
Transporting the server
Only transport the server in its original packaging or in packaging that
●
protects it from impacts and jolts.
For the Japanese market, transporting the device in its original packaging
does not apply.
Do not unpack the server until it is at its installation location.
●
3.2

CE conformity

The system complies with the requirements of the EC directives
2004/108/EC regarding "Electromagnetic Compatibility" and
2006/95/EC "Low Voltage Directive" and the directive of the
European Parliament and Council 2011/65/EU. This is indicated
by the CE marking (CE = Communauté Européenne).
3.3

FCC Class A Compliance Statement

If there is an FCC statement on the device, it applies to the products covered in
this manual, unless otherwise specified herein. The statement for other
products will appear in the accompanying documentation.
NOTE:
This equipment has been tested and found to comply with the limits for a
"Class A" digital device, pursuant to Part 15 of the FCC rules and meets all
requirements of the Canadian Interference-Causing Equipment Standard
ICES-003 for digital apparatus. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in strict accordance with the instructions, may cause harmful
interference to radio communications. However, there is no warranty that
interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
●
Increase the separation between equipment and the receiver.
●
34 Upgrade and Maintenance Manual
TX1310 M1