Replacing A 3.5-Inch Hdd; Preliminary Steps; Removing The Defective 3.5-Inch Hdd - Fujitsu PRIMERGY TX1310 M1 Upgrade And Maintenance Manual

7.4

Replacing a 3.5-inch HDD

Customer Replaceable Unit
(CRU)
Tools: tool-less
V
CAUTION!
All hard disk drives must be uniquely identified so that they can be
reinstalled in their original mounting locations later. If this is not done,
existing data can be lost.
7.4.1

Preliminary steps

"Shutting down the server" on page 40
Ê
"Disconnecting the server from the mains" on page 41
Ê
"Removing the side cover" on page 42
Ê
"Locating the defective component" on page 39
Ê
Only applicable for removing intact hard disk drives:
Ê Before removing a non-defective hard disk drive, put the hard disk drive into
"Offline" mode using your RAID configuration software.
I
For further information, please refer to the "ServerView Suite RAID
Management" user guide.
7.4.2

Removing the defective 3.5-inch HDD

Ê Remove the hard disk drive as described in section
HDD" on page
TX1310 M1
93.
Upgrade and Maintenance Manual
Hard disk drives
Hardware: 5 minutes
"Removing a 3.5-inch
97