Figure 105: Connected points of the EMI spring of bay 2
Figure 106: Connected points of the EMI spring of bay 2
Ê Cut the three connected points of the EMI spring with a diagonal pliers.
Ê Remove the EMI spring.
Ê Install the RDX drive.
I
The RDX drive is a little harder to insert than an ODD and the bezel of
the drive is touching the front panel.
V
CAUTION!
You cannot re-install the EMI spring.
If you want to remove the RDX drive, you have to install a dummy drive
instead, refer to
TX1310 M1
"Installing the dummy drive" on page
Upgrade and Maintenance Manual
Accessible drives
176.
163