Swapping The Processor; Concluding Steps - Fujitsu PRIMERGY TX1310 M1 Upgrade And Maintenance Manual

14.4.3.2 Swapping the processor

V
CAUTION!
Be careful not to touch or bend the pins on the processor socket!
I
Save the socket cover for future use. Always replace the socket cover if
you remove the processor from the socket.
Ê Carefully remove the processor from its socket on the defective system
board as described in section
Ê Install the processor on the new system board as described in section
"Installing a processor" on page

14.4.4 Concluding steps

Ê Reconnect all cables to the system board. For a complete cabling overview,
please refer to section
"Installing the TPM" on page 196
Ê
Ê Install all memory modules, see section
page 136.
I
Make sure that you reinstall each memory module in the slot it was
located before the replacement.
Ê Install the heat sink, see section
Ê Install all expansion cards see section
I
Make sure that you reinstall each card in the slot it was located before
the replacement.
"Installing the HDD cage" on page 59
Ê
"Installing the front cover" on page 48
Ê
Ê Install all removed accessible drives as described in section
accessible drives" on page
"Installing the side cover" on page 53
Ê
"Connecting the server to the mains" on page 54
Ê
Ê Connect all external cables.
"Updating or recovering the system board BIOS" on page 68
Ê
TX1310 M1
"Removing processor" on page
150.
"Cabling plans" on page
(if applicable)
"Installing the heat sink" on page
49.
Upgrade and Maintenance Manual
System board and components
218.
"Installing a memory module" on
"Expansion cards" on page
145.
156.
123.
"Installing
215