Using The Self-Strip Assembly - Intermec 4630 User Manual

4630 and 4830 Bar Code Label Printers User's Manual
7. Slide the media retainer onto the rewind hub so it's just touching the media
8. Close the stock door.
To remove media or media backing from the rewind hub
1. Open the stock door.
2. Loosen the thumb screw on the media retainer and remove it.
3. Pull the media and core off of the rewind hub.

Using the Self-Strip Assembly

You can order the printer with the self-strip assembly option or you can
purchase this option separately and have it installed by an Intermec service
technician. You must have the media rewind hub option on your printer in
order to use the self-strip assembly.
The label taken sensor is part of the self-strip assembly and it prevents the
printer from printing a new label until the last printed label has been removed
from the printer.
2-18
core and tighten the thumbscrew.
Note: If you have wound media or media backing directly on the rewind hub, pull
on the rewind hub tension bar. This will release the tension on the media so you
can remove the media from the hub.