Intermec 4630 User Manual page 78

4630 and 4830 Bar Code Label Printers User's Manual
Error Message
MEMORY RESET
OPERATION FAULT
OVERFLOW ERROR
32
OVERFLOW ERROR
37
OVERFLOW ERROR
42
OVERFLOW ERROR
43
OVERFLOW ERROR
53
PAPER FAULT
PAPER PATH OPEN
PARAMETER ERROR
8
PARAMETER ERROR
11
4-8
Problem
Portions or all of the static memory
were found to be corrupted and were
reset. Some or all of the fonts, UDCs,
formats, configuration settings, etc.,
may have been lost.
The printer microprocessor has
detected an internal fault.
Non-immediate command or data
received with full buffer.
Not enough room in the printer
memory to print the label format. The
format fits into memory but there is
not enough memory left to print.
Not enough room in the printer
memory to store the format.
Too many fields in the label format.
Not enough room for graphic or user-
defined font in the label format.
You are out of media, there is a jam in
the paper path, or the printer cannot
find a label or index marker in the
expected place.
The printer is open or not properly
closed.
Invalid start or stop characters.
Invalid data characters.
Solution
Contact your Intermec representative.
Contact your Intermec representative.
Send message after buffer has cleared.
Press Cont to clear the alert.
Reduce the format complexity by
deleting fields or decreasing the
amount of data. Press Cont to clear the
alert.
Delete any formats, fonts, or graphics
that you no longer need. If the format
still does not fit, delete a few fields or
other data from the format. Press Cont
to clear the alert.
Note: To see how much printer memory is
available, enter <ESC>m at the host.
Delete some fields, or reduce the
number of characters in the fields.
Press Cont to clear the alert.
Delete any formats, fonts, or graphics
that you no longer need. If there is still
not enough room, reduce the size of
the font or graphic. Press Cont to clear
the alert.
Open the printer and check the media
path. Make sure the Label Stock and
Media Length parameters are set
correctly (refer to Chapter 2). Press
Feed/Reload to clear the alert.
Make sure the printer is closed. Press
Feed/Reload to clear the message.
Verify start and stop characters in the
label format. Press Cont to clear the
alert.
Verify data characters in label format.
Press Cont to clear the alert.