Printing A Configuration Test Label - Intermec 4630 User Manual

5. Pull the free end of the ribbon under the printhead carriage, lower the
printhead, and engage the printhead latch. Do not lock the printhead into
position.
6. Pull the ribbon over the ribbon idler rollers, wrap the free end of the ribbon
counterclockwise around the ribbon take-up hub, and slide the J-hook
ribbon clasp into place. Rotate the hub until all slack is removed from the
ribbon (do not use the J-hook to rotate the hub).
7. Rotate the latch wing clockwise one-half turn to lock the printhead into
position and then close the stock door.

Printing a Configuration Test Label

Once media is loaded in the printer, you are ready to print the configuration
test label. Use this label for reference when connecting the printer to your
system and for verifying proper printer operation.
To print the configuration test label
1. Start with the printer display showing OFFLINE READY. You may need to
press On line/Off line to get this display.
2. Press and release the menu panel access door to open the door. From the
menu panel, press Menu and then press ↑ or ↓ until you reach the Service
menu.
3. Press Select and then press ↑ or ↓ until the display shows:
SERVICE MENU
PRINT CONFIG
1
Getting Started
1-9