4630 and 4830 Bar Code Label Printers User's Manual
Command Tables, Load
Downloads a command table, with t as the command table identifier. This is
Purpose:
followed by the nibblized command entries (c1 - cn) to be loaded into the table.
To change an entry in the table, the entire table must be sent to the printer as a
string of ASCII characters in hexadecimal form. Any entry not redefined
retains its old value. The printer expects two hex digit bytes for every entry in
the table.
Syntax:
C t, command 1, command 2, ... command n
t can range from 0 to 4. t is the command table identifier.
Data must be nibblized ASCII characters ranging from 0 to 9 and A to F.
New commands become effective after the printer is reset or the power is
Notes:
cycled. Command tables are listed later in this chapter.
Current Edit Session, Save
Purpose:
Saves the current page, format, UDC, or UDF being edited. The printer remains
in Program mode.
Syntax:
N
Field, Delete
Purpose:
Deletes field n from the format.
Syntax:
D n
n values can range between 0 and 199.
Default:
n = 0
Notes:
The last field in a format cannot be deleted. If the current field is deleted, the
field pointer points to the next field. If you delete a master field, you also delete
all slave fields of that master field.
6-54