Intermec 4630 User Manual page 33

6. Depending on the PC port the printer is connected to, type the following
commands from the DOS prompt and press Enter after each line:
Serial Port
MODE COM1: 96,E,7,1
COPY CON COM1
ABCDEF^Z
where:
MODE COM1:
COPY CON COM1
COPY CON LPT1
ABCDEF
^Z (Ctrl-Z)
The printer prints each character it receives and the hexadecimal value for
that character.
7. Press Cont on the printer menu panel to return to the OFFLINE READY
display. Data Line Print mode is automatically disabled when you exit the
Service menu.
If this test does not work, check to make sure that the communication settings
of the PC serial port match the settings of the printer serial port and that the
printer cable is securely plugged into the serial or parallel port on the PC and
the printer.
Parallel Port
COPY CON LPT1
ABCDEF^Z
configures the PC serial port, COM1, for the
communication values you specify. For example,
96,E,7,1 configures the PC serial port for 9600 baud, even
parity, 7 data bits, and one stop bit.
Note: The values you specify must match the values of the
printer serial port.
copies anything you type after this command to COM1 or
to LPT1.
random characters typed at the host.
stops the COPY CON command and sends the
information to the printer.
1
Getting Started
1-15