Increasing Image Memory; Using The Media Rewind Hub - Intermec 4630 User Manual

Note: You cannot move storage memory modules from printer to printer without
reloading the module contents.

Increasing Image Memory

The 4630 and 4830 printers come with 1MB of image memory. You can add
4MB or 16MB of image memory to the printer in order to print longer labels.
The following table shows the maximum length of the labels you can print
based on the amount of image memory in your printer.
Image Memory
Standard (1MB)
5MB
17MB

Using the Media Rewind Hub

The media rewind hub is an option that you can purchase with your printer to
spool printed label media. This option is necessary if you need to print large
quantities of labels as a single batch or that you want to use at a later time. The
rewind hub is also necessary if you want to use the self-strip option.
To use the media rewind hub
1. Open the stock door.
2. Load your label media and feed it through the printer until approximately
3. Route the media around the rewind bracket and insert it through the media
4. If necessary, loosen the thumbscrew on the media retainer and remove the
5. Pull on the rewind hub tension bar in order to slide the core adapters onto
6. Slide an empty media core onto the media rewind hub and wrap the media
Maximum Label Length
4630
8 in. (20 cm)
50 in. (127 cm)
200 in. (508 cm)
18 inches (46 cm) of media extend from the front of the printer.
take-up slot.
retainer from the media rewind hub.
the rewind hub. Adjust the core adapters to the size of your media core and
then use the thumbscrews to tighten them to the hub.
around the core by turning the hub counterclockwise several turns.
Note: You may rewind media directly on the rewind hub; however, for best results,
Intermec recommends using a media core.
Operating and Configuring the Printer
4830
6 in. (15 cm)
35 in. (89 cm)
150 in. (381 cm)
2
2-17