Auto-Transmit 3, Enable
Enables auto-transmit level 3.
Purpose:
Syntax:
<ESC>e
Status response codes:
<HT>
<SOH>
<RS>
Notes:
The printer automatically transmits the status response codes when necessary.
Auto-Transmit 1, 2, and 3, Disable
Purpose:
Disables auto-transmit status.
Syntax:
<ESC>k
Control Panel Access Permission, Set
Purpose:
Sets a security level to restrict access to certain menus depending on the value
of n.
Syntax:
<SI>A n
n = 0
n = 1
n = 2
n = 3
Default:
n = 0
Cutter, Enable/Disable
Purpose:
Turns the cutter on or off, if a cutter is installed.
Syntax:
<SI>c n
n = 0
n ≠ 0
n = 0
Default:
Notes:
This command becomes effective after a printer reset or power up.
Imager overrun
Printing is done and the buffer is empty
Insufficient RAM for printing or storage
Allows access to all menus (operator, configuration, installation, and
test and service).
Allows access to operator and configuration menus only.
Allows access to the operator menu only.
Denies access to all menus.
Disables cutter.
Enables cutter.
Configuration Commands
6
6-31