Printing Data Sent From The Host - Intermec 4630 User Manual

To print test labels of pages, formats, fonts, or graphics
1. From the OFFLINE READY display, press Menu and then press ↑ or ↓
2. Press Select and then press ↑ or ↓ until you see the item you want to print,
3. Press Select and then press ↑ or ↓ until the display shows the number of
4. Press Select. The display shows one of the following prompts:
5. Press Enter at the EXECUTE TEST prompt to print the test label.

Printing Data Sent From the Host

If you need a hard copy of the data that is sent to the printer from the host, you
can set the printer to Data Line Print. When the printer is in Data Line Print
mode, it prints all incoming data as ASCII characters (including control
characters) with the hexadecimal value underneath each character.
To access Data Line Print mode
1. From the OFFLINE READY display, press Menu and then press ↑ or ↓
2. Press Select and then press ↑ or ↓ until the display shows:
3. Press Select and then press ↑ or ↓ to enable Data Line Print mode.
4. Press Enter to activate Data Line Print mode.
Exit the Service menu to disable Data Line Print mode.
Note: If you press Feed/Reload while the printer is in Data Line Print mode, the
software version number is transmitted to the host. You can use this feature to perform
a loop-back test at the communications port.
until you reach the Service menu.
for example:
SERVICE MENU
PRINT PAGE
the item you want to print.
•
If you selected all pages, all formats, or any fonts or graphic, the display
shows an EXECUTE TEST prompt.
•
If you selected a specific page or format, press ↑ or ↓ until you reach the
number of copies you want to print, and then press Select.
until you reach the Service menu.
SERVICE MENU
DATA LINE PRINT
4
Troubleshooting
4-13