4630 and 4830 Bar Code Label Printers User's Manual
Dark Adjust, Set
Sets the dark adjust command. This controls the print darkness on the labels.
Purpose:
Syntax:
<SI>d n
n ranges from -10 to 10.
Default:
n = 0
Notes:
This command changes the configuration setting.
End-of-Print Skip Distance, Set
Sets the end-of-print skip distance. This distance is a number measured in 5 mil
Purpose:
increments that the label advances after printing. This command works for
continuous label stock and for gap and mark label stock at the end of a batch
print when label retract is enabled.
Syntax:
<SI>D n
n must be a number from 16 to 9999 in 5 mil increments.
Default:
n = 0
n = 94
Notes:
To advance the label out to the tear bar in label stock mode, set n to 90. If you
enter a value for n, it applies to both continuous mode and label stock mode,
regardless of the mode in which the value was entered.
Entering the <SI>D command without setting any parameters returns the
setting to its default value.
IBM Language Translation, Enable/Disable
Purpose:
Turns the IBM language translation feature on or off.
Syntax:
<SI>i n
n = 0
n = 1
n = 0
Default:
This feature allows IBM compatible characters to replace standard ASCII
Notes:
characters based on the current printer language. This command overrides the
language translation that is based on the current printer emulation.
6-32
Gap and Mark label stock mode.
Continuous stock mode.
Disable IBM translation.
Enable IBM translation.