Peel-Off (Self-Strip) - Intermec EasyCoder PM4i User Manual

Chapter 4— Media Load

Peel-Off (Self-strip)

The EasyCoder PM4i can print on labels, tickets, tags, and continuous
stock in various forms. This section describes the case when self-adhesive
labels are separated from the liner immediately after printing, which
requires optional integral self-strip unit with liner takeup. This is also
known as "Self-strip" operation.
Peel-off operation cannot be performed with an optional fan-fold guide
fitted.
Use the <Feed> key (see figure #14) when loading the same type of
media. When switching to a new type of media, or if the printer does
not feed out the media properly, simultaneously press the <Shift> and
<Feed> keys to perform a "testfeeed."
Peel-off can only be used for:
• Self-adhesive labels with liner
An optional label-taken sensor can hold the printing of the next label
in a batch until the present label has been removed, see Chapter 9,
"Options."
Note: Peel-off operation sets high demands on the media in
regard of label stiffness, release characteristics of the adhesive
and liner, resistance against electrostatic charging etc., so the
labels will be dispensed properly. Consult your media supplier
or test the media to ascertain that it is suitable for your applica-
tion.
 Intermec EasyCoder PM4i—User's Guide (Fingerprint version)