Intercharacter Delay, Set
Sets the intercharacter delay equal to n in milliseconds. The intercharacter
Purpose:
delay is the time delay between characters in a message transmitted by the
printer.
Syntax:
<SYN> n
n must be a number from 0 to 9999, in milliseconds.
Default:
n = 0
Label Rest Point, Adjust
Purpose:
Adjusts the point at which labels are presented for removal. Positions the gap
on the tear bar when using form feed. This command is used mostly for Self-
Strip and Cutter applications.
Syntax:
<SI>f n
The range for n is from -20 (furthest back) to +20 (furthest forward) in 5 mil
increments.
Default:
n = 0
Label Retract, Enable/Disable
Purpose:
Turns the label retract option on or off.
Syntax:
<SI>R n
n = 0
n ≠ 0
Default:
n = 1
Notes:
For die-cut label stock, the printer determines the retract distance
automatically.
For continuous label stock, the printer uses the retract distance set by the Set
Label Retract Distance command. See also Select Label Stock Type command.
This command becomes effective after a printer reset or power up.
Disables label retract.
Enables label retract.
Configuration Commands
6
6-33