Loading Media For Peel-Off (Self-Strip) Operation - Intermec EasyCoder PD42 User Manual

Loading Media for Peel-Off (Self-Strip) Operation

EasyCoder PD42 Printer User's Guide
8 Press the Print button to advance the media ("Feed"). If you
are switching to a new type of media, for instance going from
tickets with gaps to ticket with black marks, you must run a
"Testfeed" ( ) to calibrate the printer's sensors.
This section describes the case when self-adhesive labels are
separated from the liner immediately after printing. This method
is also known as self-strip operation. The label-taken sensor can
hold the printing of the next label in a batch until the present
label has been removed. You can only use self-adhesive labels with
liner in peel-off operation. Use the same procedure when
installing media for Batch Takeup, with the difference that both
label and liner is rewound, and the label-taken sensor is not used.
Note: These modes of operation require an internal rewinder
unit, for more information see Appendix A,
Interfaces, and Options."
To load media for peel-off operation
1 Remove the thumbscrew to remove the front cover.
2 Open the side door, mount the media roll, and route the
media through the media feed rods (refer to Steps 1-4 in
load media for tear-off operation" on page
Chapter 2 — Installing the Printer
"Specification,
14).
"To
17