Specifying The Tcp/Ip Settings - Muratec MFX-2590 Administrator's Manual

Function
Scan to Print
Clear
Initiliaze
Service Setting
Network
Connection
Note
Underlined values are the default settings specified at the time of shipment.

Specifying the TCP/IP Settings

You can set the settings for using the machine on a network. The following items can be
set.
Item
Host Name
Workgroup
DNS Server Addresses
DNS Suffix
Obtain IP address (DHCP)
IP Address
Subnet Mask
Default Gateway
WINS Server Address
Description
You can delete the printers
registered in the Scan to Print
Monitor from the machine.
Use this function when the
computer using the Scan to Print
Monitor cannot access the machine.
You can initialize the service
settings specified in the machine
policy settings of OfficeBridge
from the machine. Use this
function when you cannot access
OfficeBridge.
You can set the communication
speed for the LAN that is
connected.
Enter the host name of the machine.
The default setting is the MAC address, and up to 15 characters
can be entered.
Enter the workgroup name of the network the machine is
connected to.
The default setting is "WORKGROUP", and up to 15 characters
can be entered.
When using a DNS server, enter the primary DNS server
address and the secondary DNS server address.
To perform name resolution using only a host name, register the
DNS suffix.
Enables the setting for automatically obtaining IP addresses
using a DHCP (Dynamic Host Configuration Protocol) server. To
automatically obtain IP addresses, select [ON]. Otherwise, select
[OFF].
Enter the IP address.
Note
If DHCP is enabled, you cannot display or edit the IP address.
Enter the subnet mask.
Note
If DHCP is enabled, you cannot edit the subnet mask.
If you are using a gateway, enter the gateway address.
If you are using a WINS server, enter the WINS server address.
Settings
Auto
100Mbps - Full Duplex
100Mbps - Half Duplex
10Mbps - Full Duplex
10Mbps - Half Duplex
Description
Specifying the Network Settings
Reference page
2-43
1
2