Setting The Passcode - Muratec MFX-2590 Administrator's Manual

6
Press [Passcode Polling].
7
Select [ON] and press [Enter].
Press [OFF] to disable passcode polling.

Setting the Passcode

Set the passcode required for closed transmission, closed reception, and passcode polling.
You can use closed transmission and reception without setting a passcode; however,
setting a passcode is recommended to strengthen the security function.
Note
• When setting the passcode, enter a number other than "0000". If you enter "0000",
the passcode setting is disabled.
• Make sure that you do not forget the passcode.
• For details on the communication range using closed communication and passcodes,
refer to "Communication and Range of
1
Press <Setting>.
2
Press the [Management] tab.
3
If an administrator password is set,
If an administrator password is not set, proceed to step 5.
4
Enter the administrator password, and press [Enter].
5
Press [Security Communication].
2-12 Closed Communication
Passcodes". (See page 2-14.)
press [Admin Password].