Table of Contents
Advertisement
mac-access permission
This command sets a default action (allow or deny) for all unknown MAC addresses (those not
listed in the local MAC database).
Syntax
mac-access permission <allowed | denied>
• allowed ‐ Only MAC addresses entered as "denied" in the address filtering table are
denied.
• denied ‐ Only MAC addresses entered as "allowed" in the address filtering table are
allowed.
Default Setting
allowed
Command Mode
Interface Configuration (Wireless)
Interface Configuration (Wireless): VAP
Command Usage
Use this command for the default interface or any of the seven VAPs configurable per radio
interface.
Example
The following example shows setting mac‐access permission for the default interface and a VAP
RoamAbout 3000#configure
Enter configuration commands, one per line. End with CTRL/Z
RoamAbout 3000(config)#interface wireless g
Enter Wireless configuration commands, one per line.
RoamAbout 3000(if-wireless g)#mac-access permission denied
RoamAbout 3000(if-wireless g)#vap 3
RoamAbout 3000(if-wireless g: VAP[3])#mac-access permission denied
RoamAbout 3000(if-wireless g: VAP[3])#end
RoamAbout 3000(if-wireless g)#
Related Commands
mac‐access entry page A‐96
show authentication page A‐100
RoamAbout Access Point 3000 Configuration Guide A-95
Command Groups
Advertisement
Table of Contents
