Ibss Relay - Enterasys ROAMABOUT 3000 Configuration Manual

Command Groups

ibss relay

This command enables or disables IBSS relay per interface or VAP. Use the no form to disable IBSS
relay.
Syntax
ibss-relay
no ibss-relay
Default Setting
Enable
Command Mode
Interface Configuration (Wireless)
Interface Configuration (Wireless): VAP
Command Usage
• Use this command for the default interface or any of the seven VAPs configurable per radio
• In conjunction with the filter ibss-relay command settings, controls whether clients
• If you enable IBSS Relay, clients can establish wireless communications with each other
Example
The following example shows enabling the ibss‐relay on the default interface and on a VAP.
RoamAbout 3000#configure
Enter configuration commands, one per line. End with CTRL/Z
RoamAbout 3000(config)#interface wireless g
Enter Wireless configuration commands, one per line.
RoamAbout 3000(if-wireless g)#ibss-relay
RoamAbout 3000(if-wireless g)#vap 1
RoamAbout 3000(if-wireless g: VAP[1])#ibss-relay
RoamAbout 3000(if-wireless g: VAP[1])#end
RoamAbout 3000(if-wireless g)#
A-134
interface.
associated with the default radio interface or a VAP can establish wireless communications
with each other through the AP.
through the AP. If you set the filter ibss-relay command to All VAP, then clients
associated with all IBSS enabled radio interfaces or VAPs can establish wireless
communications with each other. If you set the filter ibss-relay command to Per
VAP, only the clients associated with the same (IBSS enabled) radio interface or VAP can
communicate with each other.