Interface Commands; Interface Commands (Ethernet And Wireless - Enterasys ROAMABOUT 3000 Configuration Manual

Command Groups

Interface Commands

The commands described in Table
Ethernet port and wireless interface.
Table A-15 Interface Commands (Ethernet and Wireless)
Command
General Interface
interface
Ethernet Interface
cdp authentication
cdp auto-enable
cdp disable
cdp enable
cdp hold-time
cdp tx-frequency
show cdp
dns
ip address
ip dhcp
shutdown
show interface
ethernet
Wireless Interface
description
secure-access
speed
channel
turbo
A-106
A‐15 are used to configure connection parameters for the
Function
Enters specified interface configuration
mode
Specifies an authentication key for CDP
packets
Set CDP in auto-enable mode
Set CDP in disable mode
Set CDP in enable mode
Sets amount of time that AP holds
neighbor entry
Set CDP transmit frequency
Displays CDP global settings, neighbor
entries, traffic statistics or port.
Specifies the primary or secondary name
server
Sets the IP address for the Ethernet
interface
Submits a DHCP request for an IP
address
Disables the Ethernet interface
Shows the status for the Ethernet
interface
Adds a description to the wireless
interface
When enabled, the Access Point denies
access to wireless clients that do not use
the correct wireless network name.
Configures the maximum data rate at
which a station can connect to the
access point
Configures the radio channel
Configures turbo mode to use a faster
data rate
Mode Page
GC A-109
IC-E A-110
GC A-111
GC A-112
GC A-113
GC A-114
GC A-115
Exec A-116
IC-E A-118
IC-E A-119
IC-E A-121
IC-E A-122
Exec A-123
IC-W A-124
IC-W: VAP
IC-W A-125
IC-W: VAP
IC-W A-126
IC-W A-127
IC-W A-128