Table of Contents
Advertisement
rogue-ap enable
This command enables rogue AP on the 802.11a or 802.11g interfaces. Use the no version of this
command to disable the rogue AP feature.
Syntax
rogue-ap [interface-a | interface-g] enable
no rogue-ap [interface-a | interface-g]
Default Setting
None
Command Mode
Global Configuration
Command Usage
N/A
Example
RoamAbout 3000#configure
Enter configuration commands, one per line. End with CTRL/Z
RoamAbout 3000(config)#rogue-ap interface-a enable
configure either syslog or trap or both to receive the rogue APs
detected.
Related Commands
N/A
RoamAbout Access Point 3000 Configuration Guide A-159
Command Groups
Advertisement
Table of Contents
