Package Contents
Figure 1-1
You do not have to carry out any extra configuration to work with the WS-AP3765 and
WS-AP3767e access points. For configuration information, see the Enterasys Wireless Convergence
Software User Guide.
Package Contents
The following components are supplied with the WS-AP3765 and WS-AP3767e packages:
•
Five caps for the cover screws
•
Depending on the version, up to 8 plugs for sealing the housing.
•
Depending on the version, up to 8 strain relief clamps
•
One tooth washer for the ground terminal
•
24V DC cable connector (shipped installed in place in the AP housing)
•
A printed copy of the Quick Reference for your access point model.
Confirm that each access point package is complete. If the package is not complete, contact your
supplier or your local Enterasys sales office.
1-2 Introduction
Enterasys Wireless Outdoor WS-AP3765 and WS-AP3767e Access Points
Note: These access points require configuration and control from the Enterasys Wireless
Controller.
Warning: The WS-AP3765 and WS-AP3767e access points must not be installed in an explosive
atmosphere.
Note: In this document, when the term "WS-AP3765" is used, it refers to both the "i" and "e" models.
A specific model number is called out only when the information differs by model.