Table of Contents
Advertisement
System Log
Using the CLI to Configure SNTP
To enable SNTP support on the access point, from the global configuration mode specify SNTP
server IP addresses using the sntp‐server ip command, then use the sntp‐server enable command
to enable the service. Use the sntp‐server timezone command to set the time zone for your
location, and the sntp‐server daylight‐saving command to set daylight savings. To view the
current SNTP settings, use the show sntp command from the Exec mode.
The following example shows how to manually set the system time when SNTP server support is
disabled on the access point.
4-46 Advanced Configuration
RoamAbout 3000#configure
Enter configuration commands, one per line. End with CTRL/Z
RoamAbout 3000(config)#sntp-server ip 1 10.1.0.19
RoamAbout 3000(config)#sntp-server enable
RoamAbout 3000(config)#sntp-server timezone +8
RoamAbout 3000(config)#sntp-server daylight-saving
Enter Daylight saving from which month<1-12>: 3
and which day<1-31>: 31
Enter Daylight saving end to which month<1-12>: 10
and which day<1-31>: 31
RoamAbout 3000(config)#exit
RoamAbout 3000#show sntp
SNTP Information
=========================================================
Service State
SNTP (server 1) IP: 10.1.0.19
SNTP (server 2) IP: 192.43.244.18
Current Time
: 19 : 35, Oct 10th, 2003
Time Zone
: +8 (TAIPEI, BEIJING)
Daylight Saving : Enabled, from Mar, 31th to Oct, 31th
=========================================================
RoamAbout 3000#
RoamAbout 3000#configure
Enter configuration commands, one per line. End with CTRL/Z
RoamAbout 3000(config)#no sntp-server enable
RoamAbout 3000(config)#sntp-server date-time
Enter Year<1970-2100>: 2003
Enter Month<1-12>: 10
Enter Day<1-31>: 10
Enter Hour<0-23>: 18
Enter Min<0-59>: 35
RoamAbout 3000(config)#exit
RoamAbout 3000#
: Enabled
Advertisement
Table of Contents
