802.1X Session-Timeout - Enterasys ROAMABOUT 3000 Configuration Manual

802.1x session-timeout

This command sets the time period after which a connected client must be re‐authenticate. Use the
no form to disable 802.1x re‐authentication.
Syntax
802.1x session-timeout <seconds>
no 802.1x session-timeout
seconds is the number of seconds. Range: 0‐65535
Default Setting
0 (Disabled)
Command Mode
Interface Configuration (Wireless)
Interface Configuration (Wireless): VAP
Command Usage
Use this command for the default interface or any of the seven VAPs configurable per radio
interface.
Example
The following example shows setting 802.1x session‐timeout for the default interface and a VAP
RoamAbout 3000#configure
Enter configuration commands, one per line. End with CTRL/Z
RoamAbout 3000(config)#interface wireless a
Enter Wireless configuration commands, one per line.
RoamAbout 3000(if-wireless a)#802.1x session-timeout 300
RoamAbout 3000(if-wireless a)#vap 2
RoamAbout 3000(if-wireless a: VAP[2])#802.1x session-timeout 300
RoamAbout 3000(if-wireless a: VAP[2])#
RoamAbout 3000(if-wireless a: VAP[2])#exit
RoamAbout 3000#
Related Commands
show interface wireless page A‐151
802.1x page A‐89
802.1x session‐key‐refresh‐rate page A‐92
RoamAbout Access Point 3000 Configuration Guide A-93
Command Groups