Table of Contents
Advertisement
Command Groups
vlan
This command enables VLANs for all traffic on the specified radio interface. Use the no form to
disable VLANs.
Syntax
vlan enable
no vlan
Default Setting
Disabled
Command Mode
Interface Configuration (wireless)
Command Description
• Changing the VLAN status of the access point requires a system reboot.
• When VLANs are enabled, the access point tags frames received from wireless clients with
• If the VLAN ID has not been configured for a client on the RADIUS server, then the frames
• When using IEEE 802.1x to dynamically assign VLAN IDs, the access point must have
• Traffic entering the Ethernet port must be tagged with a VLAN ID that matches the access
Example
RoamAbout 3000#configure
Enter configuration commands, one per line. End with CTRL/Z
RoamAbout 3000(config)#interface wireless a
RoamAbout 3000(if-wireless a)#vlan enable
Reboot system now? <y/n>: y
Username:
Related Commands
native‐vlanid page A‐175
A-174
the native VLAN ID for the radio interface. If IEEE 802.1x is being used to authenticate
wireless clients, specific VLAN IDs can be configured on the RADIUS server to be assigned
to each client. Using IEEE 802.1x and a central RADIUS server, up to 64 VLAN IDs can be
mapped to specific wireless clients.
are tagged with the native VLAN ID of the radio interface.
802.1x authentication enabled and a RADIUS server configured. Wireless clients must also
support 802.1x client software.
point's management VLAN ID, a radio interface native VLAN ID, or with a VLAN tag that
matches one of the wireless clients currently associated with the access point.
Advertisement
Table of Contents
