Qos Mac-Addr; Qos Ether-Type - Enterasys ROAMABOUT 3000 Configuration Manual

Command Groups

qos mac-addr

This command allows you to enter up to ten MAC addresses and the priority.
Syntax
qos mac-addr <mac address> <0 - 7>
mac address is the MAC address of the client that you want to assign the priority.
0 ‐ 7 is the priority.
Default Setting
None
Command Mode
Global Configuration
Example
RoamAbout 3000#configure
RoamAbout 3000(config)#qos mac-addr 00-01-f4-32-62-ac 6
RoamAbout 3000(config)#

qos ether-type

This command allows you to enter the Ethernet types in the Ethernet type table, and the priority
class. The Ethernet type must be specified in the format HEX 0000‐FFFF.
Syntax
qos ether-type <0000-FFFF> <0 - 7>
0000‐FFFF is the Ethernet type as specified in the Ethernet type table.
0 ‐ 7 is the priority.
Default Setting
None
Command Mode
Global Configuration
Example
RoamAbout 3000#configure
Enter configuration commands, one per line. End with CTRL/Z
RoamAbout 3000(config)#qos ether-type 0800 6
RoamAbout 3000(config)#
A-156
Note: You must configure at least one MAC address classification before the source or destination
address-based qos mode will take affect.
Note: You must configure at least one Ethernet type classification before the Ether type-based qos
mode will take affect.