Table of Contents
Advertisement
cdp enable
This command enables this AP to use Cabletron Discovery Protocol (CDP) and to send
information about itself at the specified Transmit Frequency.
Syntax
cdp enable
Default Setting
Auto
Command Mode
Global Configuration
Command Usage
If you set CDP to enable mode, specify a transmit frequency.
Example
RoamAbout 3000#configure
Enter configuration commands, one per line. End with CTRL/Z
RoamAbout 3000(config)#cdp enable
RoamAbout 3000(config)#
Related Commands
cdp authentication page A‐110
cdp disable page A‐112
cdp hold‐time page A‐114
cdp tx‐frequency page A‐115
show cdp page A‐116
RoamAbout Access Point 3000 Configuration Guide A-113
Command Groups
Advertisement
Table of Contents
