Command Groups
ip ssh-server
Use this command to enable SSH access to this access point. Use the no version of this command
to disable SSH access.
Syntax
ip ssh-server <enable>
no ip ssh-server
Default Setting
Enable
Command Mode
Global Configuration
Command Usage
The SSH protocol uses generated public keys to encrypt all data transfers passing between the
access point and SSH‐enabled management station clients and ensures that data traveling
over the network arrives unaltered.
Example
RoamAbout 3000#configure
Enter configuration commands, one per line. End with CTRL/Z
RoamAbout 3000(config)#ip ssh-server enable
RoamAbout 3000(config)#
Related Commands
ip ssh‐server port page A‐29
A-28
Note: After boot up, the SSH server requires approximately two minutes to generate host
encryption keys. The SSH server is disabled while the keys are being generated.