Table of Contents
Advertisement
Command Groups
cdp hold-time
This command specifies amount of time in seconds that the AP retains an AP neighbor entry after
receiving last Cabletron Discovery Protocol (CDP) hello packet.
Syntax
cdp hold-time <seconds>
<seconds> amount of time to retain AP neighbor entry. Range: 15‐600
Default Setting
180 seconds
Command Mode
Global Configuration
Example
RoamAbout 3000#configure
Enter configuration commands, one per line. End with CTRL/Z
RoamAbout 3000(config)#cdp hold-time 300
RoamAbout 3000(config)#
Related Commands
cdp auto‐enable page A‐111
cdp enable page A‐113
cdp tx‐frequency page A‐115
show cdp page A‐116
A-114
Advertisement
Table of Contents
