Pppoe Remote Ip - Enterasys ROAMABOUT 3000 Configuration Manual

Command Groups

pppoe remote ip

This command sets a remote IP address for the PPPoE tunnel.
Syntax
pppoe remote ip <ip-address>
ip‐address is the IP address of the remote end of the PPPoE tunnel.
Default Setting
None
Command Mode
Interface Configuration (Ethernet)
Command Usage
If you set the pppoe ip allocation mode to static, you must use this command to specify the
remote IP address and the pppoe local ip command to set the local IP address.
Example
RoamAbout 3000#configure
Enter configuration commands, one per line. End with CTRL/Z
RoamAbout 3000(config)#interface ethernet
Enter Ethernet configuration commands, one per line.
RoamAbout 3000(if-ethernet)#pppoe remote ip 192.168.1.20
RoamAbout 3000(if-ethernet)#
Related Commands
pppoe ip allocation mode page A‐47
pppoe local ip page A‐51
A-52